Aprilaire 800 residential steam humidifier is now available!! This is a brand new, genuine Aprilaire 800 Steam Humidifer.

The Aprilaire 800 Steam Humidifier is a self-contained devise that boils tap water to create steam. This system uses a distribution tube to transfer the steam to the duct work into the moving airstream. This allows for a drip free transfer! Humidifies tightly-constructed homes up to 6,200 Sq Ft.
The Aprilaire 800 steam humidifier is easy to install and maintain with no accessories required. It is designed for remote or duct mount with no additional accessories.
The Aprilaire 800 steam humidifier has very little maintenance necessary, simply remove the canister once a year and replace with a new one.
The Aprilaire 800 residential steam humidifier offers steam dispersion technology which ensures proper dispersion into the air, preventing condensation in the duct work.
Everything you need for installation is included ~ Control, dispersion tube, steam hose and drain tube included with the Aprilaire 800 steam humidifier.

• Voltage - 120V
• Supply Water pressure must be between 25 psi and 120 psi
• Drain water flushes with fresh inlet water
• Electrical draw 11.5 amps +/-10%, use 12.7 amps when sizing circuit
• 208 or 240v, run two conductors plus neutral plus ground
• Canister replacement once per humidifier season under normal conditions. Unit will automatically notify when canister must be replaced
  
  Click here to open the AP 800 Installation Manual
  Click here to open the AP 800 Owner's Manual
  
  Dimensions:
  Width: 10-1/8"
  Height: 20-7/8" 
  Depth: 7-1/8"
  
  Furnished materials:          
  Humidifier
  Automatic Digital Humidifier Control (Humidistat)
  Remote temperature sensor
  Dispersion tube
  Steam hose (6 feet)
  7/8" I.D. Drain tubing (10 feet)
  Installation instructions
  
  Additional materials that may be required:
  Low voltage wire (thermostat wire) for remote temperature sensor (length depends on sensor location)
  1/4" O.D. Supply water tubing
  Saddle valve
  Boards for mounting (if required)